How to use - Deep Cleanse Treatment

Step 1: Apply warm water to your clients face using a face cloth or flannel.  The skin must remain wet during the entire treatment.  Never use the device on dry skin.

Step 2: Turn unit on by pressing the power button until the unit engages.  This will automatically begin in cleaning mode.

Step 3: Hold the unit so that the control panel is away from the skin.

Step 4: With gentle pressure, scrape the blade over the skin using a forward movement.  You will see a fine spray of water droplets and dead skin cells being collected on the end of the blade. For best results, take your time and work slowly moving the blade at all times.

Step 5: Methodically work over all areas of the face.  Pay special attention to the corners of the nose as this area will usually produce the most extractions.  Wipe the blade when required.

Step 6: After use, turn the unit off by pressing the power button until the unit turns off. The blade may be cleaned by wiping with a damp cloth. Store the device with the protective silicone sleeve on the blade. Note: If left on, the unit will automatically turn off after 10 minutes.


IMPORTANT:- ENSURE THE DEVICE IS STERILISED WITH MEDICAL GRADE ALCOHOL WIPES BETWEEN CLIENTS.

I BUILT MY SITE FOR FREE USING